Jump instructions are always optimized to use the smallest possible displacements. This is accomplished by using byte (8-bit) displacement jumps whenever the target is sufficiently close. If a byte displacement is insufficient a long (32-bit) displacement is used. We do not support word (16-bit) displacement jumps (i.e. prefixing the jump instruction with the `addr16' opcode prefix), since the 80386 insists upon masking `%eip' to 16 bits after the word displacement is added.
Note that the `jcxz', `jecxz', `loop', `loopz',
`loope', `loopnz' and `loopne' instructions only come in byte
displacements, so that if you use these instructions (gcc does
not use them) you may get an error message (and incorrect code). The AT&T
80386 assembler tries to get around this problem by expanding `jcxz foo'
to
jcxz cx_zero
jmp cx_nonzero
cx_zero: jmp foo
cx_nonzero: