* 94/08/21 john@armory.com
* atdialer default file for AT&T DataPort

* &F0	restore factory defaults
* S0=1	enable auto-answer
* Q1	disable result codes
* M0	turn off speaker
* &D2	switch to command mode when DTR drops, hang up, disable auto-answer
* &C1	set carrier detect when remote carrier detected
* X7	Make connect message give DTE rate
*
* S2=043	escape char = +
* added to MDM_SETUP	
* \Q0	turn off flow control
* \J0	set constant-speed interface (default)
* \Q2	Unidirectional hardware flow control (output only)
* \Q3	Bidirection RTS/CTS flow control
* \G1	Enable modem-to-modem flow control
* \N1	direct mode
* \X1	Enable xon/xoff pass through flow control
* Put \J *after* \N
MDM_SETUP=AT&F0&D2&C1S0=1S2=043M0\Q3\G1X7
*MDM_SETUP=AT&F0&D2&C1S0=1S2=043M0\Q3\G1\X1
MDM_DIALCMD=ATDT
MDM_ESCAPE=+++
MDM_HANGUP=ATQ0H0
MDM_RESET=ATQ0Z
MDM_DIALIN=AT&F0S0=1Q1M0&D2&C1\Q3\G1\X1
MDM_ATTN=AT
MDM_DSBLESC=ATS2=128
RTC_OK=OK
RTC_NOCARR=NO CARRIER
RTC_ERROR=ERROR
RTC_NOTONE=NO DIALTONE
RTC_BUSY=BUSY
RTC_NOANS=NO ANSWER
RTC_300=CONNECT 300
RTC_1200=CONNECT 1200
RTC_2400=CONNECT 2400
RTC_4800=CONNECT 4800
RTC_9600=CONNECT 9600
RTC_19200=CONNECT 19200
RTC_38400=CONNECT

STTY=-IXON -IXOFF -RTSFLOW -CTSFLOW ORTSFL